Home

StoneClip Versatility

Extends from being able to:

  • Fix to all substrates

  • Use existing tools available to tradesperson

  • Fix with or without joint

  • Use at strategic points in a job such as when doing a random rubble wall and support is needed at certain points to hold big pieces of stone

  • Put the kerfs in at selected points to accommodate it you don't weaken edge by putting a continuous cut along along the top and bottom edge (this eliminates a channel for water to collect and freeze in winter. Thus, busting the front faces on the panels)

  • Adapt to be used if kerf is already cut (if kerf is wider than 2.2mm, StoneClips can be ordered with a thicker front round or dual disc, up to 3mm available)

  • Order panels already with kerf cut and a suitable StoneClip is available on consultation with our office

  • Hang and support:
    - Timber beams in vertical position
    - Aluminium panels on outside and inside of buildings

  • If you get kerf cut into panel on the hanging side in the factory, it greatly reduces cost in horizontal cladding (on it's back)